| Customization: | Available |
|---|---|
| After-sales Service: | 1 Years |
| Warranty: | 1 Years |
| Shipping Cost: | Contact the supplier about freight and estimated delivery time. |
|---|
| Payment Methods: |
|
|---|---|
| Support payments in USD |
| Secure payments: | Every payment you make on Made-in-China.com is protected by the platform. |
|---|
| Refund policy: | Claim a refund if your order doesn't ship, is missing, or arrives with product issues. |
|---|
Suppliers with verified business licenses
Audited Supplier Audited by an independent third-party inspection agency
Model | LKXP-1000 |
Size(mm) | 3100*650*1000mm |
Voltage(v) | 380 |
Power(KW) | 1.5 |
Capacity(kg/h) | 800-1500 |
Check Item | Operating Steps | Qualification Standard | |
3 checks before startup | Blade Sharpness | Lightly touch the rotating knife set with A4 paper and observe if it can cut continuously (wear protective gloves!) | Cut off without any lag or "tearing paper" phenomenon |
Silicone roller wear | Visually inspect the surface of the roller for cracks and dents, and ensure even elasticity when pressed with fingers | No cracks, rebound time after pressing<2 seconds | |
Pneumatic system | Start the air compressor, observe the pressure gauge value (0.4-0.6MPa), and listen for any air leakage sound at the air pipe interface | Stable pressure, no "hissing" air leakage sound | |
Core component maintenance checklist | Knife group bearing | Inject food grade lubricating grease into the syringe, with a grease injection volume of 0.5ml per bearing | Once a week |
photoelectric sensor | Wipe the lens with an alcohol swab and check if the indicator light is green and always on (turns red when blocked) | twice a week | |
Chain/Belt | Release the protective cover, manually move the chain, and check for any jamming (normal should be smooth without any abnormal noise) | Once a week | |
After shutdown "3 clear" | Clean up residual dandruff: | Remove the protective cover of the feeding port and use a high-pressure water gun (pressure ≤ 3bar) to flush the gap between the blade group and the mesh of the conveyor belt (to avoid bacterial growth caused by the accumulation of dandruff, in compliance with food grade hygiene requirements). | |
Wipe dry damp parts: | Wipe the motor casing and control box panel with a dry cloth (to prevent moisture from entering the circuit, especially during the southern rainy season, an additional 30 seconds of cold air blowing with a hair dryer is required). | ||
Reset adjustment component: | Adjust the peeling thickness knob to the "0" position and return the clamping force adjustment rod to the "center" position (to avoid long-term fatigue of the spring). | ||
){kind=link}